Masterbuilt 20040712 Assembly, Care & Use Manual Warning & Safety Information page 12

STEP 13a
B
D
1
B
STEP 13b
2
E
11
STEP 13a
Insert phillips head screw (D) into
2
hole on the left side of grill lid (1).
Thread hex flange nut (B) onto bolt
and tighten. Slide warming rack (2)
eyelet onto end of support bolt.
STEP 13b
D
Slide warming rack to the far left to
butt up against grill lid.
On right side of grill lid (1) hold hex
flange nut (B) in place with hand
1
and thread phillips head screw (D)
through nut, guiding warming rack
(2) onto support bolt as shown.
2
STEP 14
Note: Do not over tighten lock nut
(E). Warming rack should move
freely.
Secure warming rack (2) to phillips
head screw (D) using lock nut (E) as
shown.
Secure warming rack support arm
onto grill body (5) using phillips screw
(A) and hex lock nut (E).
Repeat step on opposite side.
A
5
19
20
A
B
STEP 15
Place firebox top (19) onto firebox
base (20).
Insert phillips head screws (A)
through holes in outer lip of firebox
as shown. Repeat on opposite side.
Tighten securely.
A STEP 16
On rear of firebox, insert tab on
firebox lid stop (24) into slot then
secure in place with phillips head
screw (A) and hex flange nut (B).
24
Insert hinges on access door (21) into
hinges on firebox base (20).
21
20
12