Dehumidifier Operating - Everstar MPK-10CR Use & Care Manual

DRY (Dehumidifier) Operating Instructions
1 ) Press the (on/off) key pad to switch on the
unit.
2) Press the MODE key until the DRY indicator
light comes on (Fig.15). Each depression of the
MODE key will advance to a different mode
setting (Cool-Dry -Fan
3) The green indicator light will come on indicating
the dehumidifying mode is operational .
IMPORTANT: Under the dehumidifying mode, you
cannot select a fan speed or adjust the temperature.
The fan motor operates at a pre-set High Fan
speed and the LED window displays the ambient
temperature.
4) To drain off the water, remove the drain plug from
the back of the unit and connect the drain hose;
then attach the other end of the drain hose to the
water tank as depicted in Fig.16a. Condensation
starts to flow into the internal tank through the
drain hose. Fig.16b. When the tank is full, the
LED window will show "P1" and the Water Full
indicator light start flashing. At this time the
Dehumidifying process will immediately stop.
However, the fan motor will continue to operate
(this is normal). Carefully remove the water tank
from the cabinet and dispose of the water.
Replace the water tank back to it's original
position (in cabinet) and the dehumidifying
process will automatically resume. It may take
3-5 minutes for the compressor to re-start. This
is normal.
5) This unit also has provisions for a continuous
"drain" option (for basement applications having
a floor drain). To connect the continuous drain
option, remove the drain plug from the back of
the unit, then connect the drain hose. Please
remember to place the open end of the hose into
a bucket or floor drain failure to comply with
these procedures may result in flooding.
Fig13 & 13a on page 8.
).
Dry Indicator
Remove the drain plug and install the drain hose.
6) To adjust "air flow" direction, (up / down only) move
the louver wheel with finger to the desired position.
Fig.14 on page 8.
9
Fig. 15
Remove the drain
plug from the back.
Fig.16
Fig.16a
Fig.16b