Everstar MPK-10CR Use & Care Manual page 18

Remote Control Operating
DRY OPERATION
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired
temperature from 7 0 F to 82 F.
3. Push the ON/OFF button. The operation lamp
lights and the air conditioner starts to operate
in the DRY mode. Push the ON/OFF button
again to stop this unit operation.
TIMER Operation
TIMER ON button can set the auto-on time of the
unit.
TIMER OFF button can set the auto-off time of the
unit.
1. To set the starting time.
1.1 Push the TIMER ON button, then the remote
controller shows TIMER ON, the last set time
for the starting operation and the signal "h" will
be shown on the DIGITAL DISPLAY area. You
are now ready to reset the time to START the
operation.
1.2 Push the TIMER ON button again to set desired
unit start time.
1.3 After setting the TIMER ON ,there will be a
one-half second delay before the remote
controller transmits the signal to the air
conditioner. Then, after approximately another
2 seconds, the signal "h" and the time setting
will disappear and the set temperature will
re-appear on the digital display.
2. To set the stopping time.
2.1 Push the TIMER OFF button and the remote
controller will show TIMER OFF, the last set
time for the stopping operation and the signal
"h" will be shown on the DIGITAL DISPLAY
area. You are now ready to reset the time of
the STOP operation.
2.2 Push the TIMER OFF button again to set the
time you want to stop the operation.
O O
2.3 After setting the TIMER OFF, there will be a
one-half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the signal
"h" and the time setting will disappear and the set
temperature will re-appear on the digital display.
3. Set the starting & stopping time
3.1 Push the TIMER ON button, the remote controller
will show TIMER ON, the last set time for START
operation and the signal "h" will be shown on the
DIGITAL display area. Y ou are now ready to
readjust the TIMER ON to start the operation.
3.2 Push the TIMER ON button again to set the time
you want to start the operation.
3.3 Push the TIMER OFF button, the remote controller
will show TIMER OFF, the last set time for STOP
operation and the signal "h" will be shown on the
DIGITAL display area. Y ou are now ready to reset
the time to STOP operation.
3.4 Push the TIMER OFF button again to set the time
you want to stop the operation.
3.5 After setting the TIMER, there will be a one-half
second delay before the remote controller transmits
the signal to the Air Conditioner. Then, after
approximately another 2 seconds, the signal "h"
and the time setting will disappear and the set
temperature will re-appear on the digital display.
NOTE
1. Please reset the TIMER after cancelling the former
time settings.
2. The setting time is relative time. That is the time set
is based on the delay of the current time.
17