Everstar MPK-10CR Use & Care Manual page 14

Setting the AUTO-ON & AUTO-OFF TIMER
Before setting the AUTO-ON & AUTO-OFF
Timer, you must also select the appropriate
operating MODE. After the appropriate settings
have been made, turn off the unit.
1) Press the TIMER-ON key pad to initiate the
AUTO-ON time sequence. Fig. 21. The display
window will indicate the time. Press the
to select the desired AUTO-ON start time.
Fig. 21a.
2) Each press of the Keypad will increase the
AUTO-TIMER setting in half an hour increments
until the LED window displays 10. Continue
pressing the Keypad, each press will increase
the AUTO-TIMER Setting in an hour increments.
When the desired time is established (the time
will display in the display window for about 5
seconds), then the temperature will immediately
revert back in the display window.
The unit must remain "OFF" while programming
the AUTO-ON program.
3) Press the TIMER-OFF key pad to initiate the
AUTO-OFF time sequence. Fig. 22. The display
window will indicate the time. Press the
to select the desired AUTO-OFF stop time.
Fig. 22a.
4) Each press of the Keypad will increase the
AUTO-TIMER setting in half an hour increments
until the LED window displays 10. Continue
pressing the Keypad, each press will increase
the AUTO-TIMER Setting in an hour increments.
When the desired time is established, (the time
will display in the display window for about 5
seconds), then the temperature will immediately
revert back in the display window.
IMPORTANT: When the unit is operational, set the
AUTO-OFF TIMER first, then set the AUTO-ON
TIMER. The AUTO-OFF time should be prior to the
AUTO-ON time. When the unit is non-operational,
set the AUTO-ON TIMER first, then set the
AUTO-OFF TIMER. The AUTO-ON time should be
prior to the AUTO-OFF time. The desired
key AUTO-ON & AUTO-OFF time will be registered
within a 5 seconds period (after pressing the
TIMER-ON/OFF keypads) .
The unit will start automatically when the specified
AUTO-ON time is achieved and will stop
automatically when the specified AUTO-OFF time is
achieved .
To cancel or override the AUTO-TIMER program,
simply turn the unit on or off prior to the scheduled
AUTO-ON/OFF time. You can vary the
AUTO-ON/OFF time selection anytime by pressing
each respective TIMER-ON / TIMER-OFF keypad
and the selected time will appear replacing the set
time.
key
13