Software Upgrade - TANDBERG Codec C60 Administrator's Manual

Codec C60
Contents Introduction

Software upgrade

The Upgrade tab lets you select the software
upgrade file for TANDBERG Codec C60 and install
the new software.
Please follow the procedure described on this
page.
D14334.02—FEBRUARY 2009
Getting started About the menus
The software upgrade procedure
Contact your TANDBERG representative to obtain the software upgrade file.
1. Open a web browser and enter the
IP address to connect to the Codec
C60 by HTTP
2. Select the Upgrade tab
3. Click Browse... and locate the
upgrade file (.PKG)
4. Click the Install software button to
start the installation.
5. Leave the system for a few minutes
to allow the installation process to
complete. The upgrade process
takes about 4–5 minutes.
Administrator settings Settings Library
Administrator Guide
Appendices
Cameras Appendices Contact us
50