Fitting The Chimney Stack - John Lewis JLBIHD105 Instruction Manual

Fitting the Upper Chimney
• Expand the sides of the upper chimney stack item 2.1 and
place the chimney over the two brackets 7.2.1 ensuring
they are well seated.
• Secure the chimney stack to the brackets 7.2.1 using
the four self tapping screws item 12c (2.9 x 9.5mm)
supplied.
Fitting the Lower Chimney
• Expand the of the lower chimney stack item 2.2 and place
the chimney over the upper chimney stack item 2.1 and
the canopy.
• Secure the chimney stack to the canopy using the two
screws item 12c (2.9 x 9.5mm) supplied..
• After the chimney has been secured into position, insert
the two plastic recirculation grilles item 8a (right-hand)
and 8b (left-hand) in the apertures on each side of the
chimney. The grilles are marked with two arrows and
should be fitted with one arrow pointing upwards and
the other toward the front.
• When the hood is used in the recirculation mode ensure
that the grilles are properly secured to the recirculation
extension spigot item 14.1.
8