Contents Instruction Manual JLCHIS901 90cm Cooker hood Introduction Safety is important In the box Safety information Important safety information Warnings Cautions Electrical information Operation Care and cleaning Cleaning and replacing baffle filters Cleaning and replacing charcoal filters Installation Installing the cooker hood...
These warnings have been provided in the interest of safety. You MUST read them carefully before using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance or our Technical Support centre on 0330 123 0106.
To avoid accidents to property or people it is important to follow the instructions given. Failure to do so removes any liability from John Lewis. Warnings – Any installation work must be undertaken by a qualified electrician or competent person.
Should the power supply cable need to be replaced, this must be carried out by an approved service engineer. John Lewis declines any liability should this safety measure not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the cooker hood’s rating plate.
Operation Instruction Manual JLCHIS901 The controls are (left to right): 90cm Cooker hood Light. Press this button to switch the lights in the cooker hood on or off. Off/Fan Speed 1. If the cooker hood is: – Off, press this button to switch the cooker hood on at fan speed 1.
Care and cleaning Instruction Manual JLCHIS901 Note: Switch off and unplug the cooker hood before carrying out any 90cm Cooker hood cleaning or maintenance work. Clean the interior and exterior casing using a cloth with water and mild (neutral) detergent.
Page 8
To replace the charcoal filters: Instruction Manual JLCHIS901 1. Remove the baffle filter (A) by turning the handle towards the rear of 90cm Cooker hood the cooker hood and pulling the filter downwards. 2. Pull the tab to release the charcoal filter (B) and remove it.
Installation Instruction Manual JLCHIS901 Note: A minimum of two people are required to perform the installation. 90cm Cooker hood The cooker hood must be mounted so that the minimum distance between the filters and the gas or electric hob is 65cm.
Page 10
6. Connect the drainpipe to the power unit nozzle and fix securely with a Instruction Manual JLCHIS901 hose clamp. 90cm Cooker hood 7. Insert the upper structure (E) into the lower structure (D) and adjust the height (the minimum distance between the filters and the gas or electric hob must be 65cm).
Installing the cooker hood (filtering/recirculation) Instruction Manual JLCHIS901 1. Prepare the power supply (see page 5). 90cm Cooker hood 2. Drill four 8mm holes in the ceiling, using the upper plate (A) as a template. 3. Insert plastic dowels into the holes.
Disposal This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK.
If none of the above suggestions resolve the problem please contact your local John Lewis branch. Never attempt to repair the cooker hood yourself. Replacing LED lights Your cooker hood is fitted with LED light bulbs. They should only be...
Specifications Instruction Manual JLCHIS901 Specifications of the cooker hood that you have just purchased may vary 90cm Cooker hood from the information in this table due to technical innovations. Model Number JLCHIS901 Type Cooker Hood Dimensions 900mm wide x 600mm deep x 755mm - 1174mm high...
Need help?
Do you have a question about the JLCHIS901 and is the answer not in the manual?
Questions and answers