Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for John Lewis JLBIHD908
Summary of Contents for John Lewis JLBIHD908
- Page 1 JLBIHD908 Built-in cooker hood Instruction manual...
-
Page 2: Important Safety Information
. You MUST read them carefully before use or installa- tion by a qualified person. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. -
Page 3: Table Of Contents
Contents For the User Important Safety Information Description of the Appliance Using the cooker hood Cooker Hood Controls To Operate Recirculation Extraction Maintenance and Cleaning External Cleaning Cleaning the Ducting panels Metal Grease Filters Charcoal Filters To Remove/Replace Charcoal Filter Changing the Halogen Spot Lamp Something Not Working Repairs and After Sales Service... -
Page 4: Description Of The Appliance
Description of the appliance... -
Page 5: Installing The Cooker Hood
Installation Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. -
Page 6: Fitting The Wall Brackets
Installing the cooker hood Fitting the wall brackets • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 850 mm above the hob. •... -
Page 7: Extraction
Extraction (Ducted) The cooker hood is more effective when installed in the extraction mode (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be evacuated through an outside vent of ø125 (5ins) or ø150mm (6ins). The ducting used must be manufactured from fire retard- ant material conforming to the relevant British Standard or DIN 4102-B1. -
Page 8: Electrical Connections
Electrical connection THIS APPLIANCE MUST BE EARTHED Electrical requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety this should be under- taken by a qualified electrician e.g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). -
Page 9: Using The Cooker Hood
Using the cooker hood The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The appliance can be installed to recirculate or extract contaminated air. Cooker hood controls The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. -
Page 10: To Operate
To operate Select the required fan speed and light if required. Recirculation In the recirculation mode the contaminated air enters the cooker hood through the grease filters. The air is cleaned by passing through the charcoal filters before being passed back into the kitchen through the grilles in either side of the chimney stack. -
Page 11: Maintenance And Cleaning
Maintenance and cleaning Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. -
Page 12: Charcoal Filters
Alarm signal reset • Stop the motor and switch off the lights. • Press button T3 for at least 3 seconds, until the LEDs start to flash. Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. -
Page 13: Changing The Halogen Spot Lamp
Reset the alarm signal • Stop the motor and switch off the lights. • Press button T3 for at least 3 seconds, until the LEDs start to flash. This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended. -
Page 14: Something Not Working
Something not working If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force agent. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or instal- lation, a charge will be made even if the appliance is under guarantee. - Page 16 John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.com 436004228_04 - 080703...