Satin Stitch - Bernina virtuosa 153 QE Owner's Manual

M
ASTERING
Y
OUR
BERNINA
®
Owner's manual pg.____
• Fold fabric in half to 3" x 6". Use stabilizer as needed.
• Select Stitch #2. Change the stitch length to satin stitch and the stitch width to 5.5mm.
• Thread the bobbin thread through the hole in the finger of the bobbin case.
• Move the needle position all the way to the left.
• Position the raw edge of the fabric on the
• Sew down this edge about 1". While continuing to sew, turn the stitch width knob to taper the stitch to
0mm. Then widen the stitch back to maximum. Repeat until the stitching reaches the end of the fabric.
• Position the fold of the fabric on the
• Move the needle position all the way to the right and stitch along the right side of the fabric, tapering
and widening the stitching while sewing.
• Move the needle position to the center and stitch down the center of the fabric, tapering and widening
the satin stitch while sewing.
BERNINA
M Y
ASTERING OUR
BERNINA

SATIN STITCH

Fabric: Firm fabric – 3 pieces, 3" x 6" each
Needle: 90/14 Embroidery
Thread: 30 wt. Cotton Embroidery
Presser Foot: Reverse Pattern Foot #1
3
/ " line (on the right side of the stitch plate).
8
3 / " line (on the left side of the stitch plate).
8
1/04/02
®
®
virtuosa 153 QE/163
virtuosa 153 QE/163/14