Sony XCD-SX910CR/X710CR Technical Manual page 28

Error
Obtain the number of packets.
XCD-SX910CR/X710CR
XCD-SX910/X710
Step 3
PixelNumber is read out.
TotalByte is read out.
PacketParaINQ is read out.
Sets the packet size.
Check the packet size.
No error
Setting completed.
Now image transmission is ready. Send a video start
command to output images.
Read F0F10034h. Number of pixels is
obtained. (Use this information if required
by the software application.)
Read F0F10038-3Ch. Total byte (of
effective image) is obtained.
Read F0F10040h. Packet size that can be
set is obtained. (1,200 (minimum) and
2,400 (maximum) for this camera.)
Write 09600960h in F0F10044h.
(PacketSize = 2400)
Read F0F1007Ch. Check that Bit 9 is not
set. If an error occurs, the PacketSize was
wrong. Try other settings.
Read F0F10048h. The number of packets
per 1 frame is obtained. (The total number
of bytes of the data output by the camera
output = Packet size × number of packets)
Control
28