Notes On Installing The Server Enclosure In The Rack - Fujitsu Primergy CX400 S2 Operating Manual

Important information
4.5 Notes on installing the server enclosure in
the rack
V
CAUTION!
For safety reasons, at least two people are required to install the
●
server enclosure in the rack because of its weight and size.
(For the Japanese market, please refer to " 安全上のご注意 ".)
Never lift the server enclosure into the rack using the handles.
●
When connecting and disconnecting cables, observe the relevant
●
instructions in the "Important Information" chapter of the operating
manual for the corresponding rack. The operating manual is supplied
with the corresponding rack.
When installing the rack, make sure that the anti-tilt mechanism is
●
correctly fitted.
For safety reasons, no more than one unit may be removed from the
●
rack at any one time during installation and maintenance work.
If several units are simultaneously removed from the rack, there is a
●
risk that the rack could tip over.
The rack must be connected to the power supply by an authorized
●
specialist (electrician).
If the server enclosure is integrated into an installation that draws
●
power from an industrial power supply network with an IEC309 type
connector, the PSU's fuse protection must comply with the
requirements for non-industrial power supply networks for the type A
connector.
32 Operating Manual
CX400 S2