Section 6 Peripheral Setup - American Megatrends Olympus Pentium II PCI ISA Manual

Section 6 Peripheral Setup

Choose Peripheral Setup from the AMIBIOS Setup main menu. All Peripheral
Setup options are described below.
Onboard FDC Set this option to Enabled to enable the floppy drive controller (FDC) on the
motherboard. The settings are Auto (AMIBIOS automatically determines if the
floppy controller should be enabled), Enabled, or Disabled. The Optimal and
Fail-Safe default settings are Auto.
Onboard Serial PortA This option specifies the base I/O port address of serial port 1. The
settings are Auto (AMIBIOS automatically determines the correct base I/O port
address), Disabled, 3F8h/COM1, 2F8h/COM2, 3E8h/COM3, or 2E8h/COM4.
The Optimal and Fail-Safe default settings are Auto.
Onboard Serial PortB This option specifies the base I/O port address of serial port 2. The
settings are Auto (AMIBIOS automatically determines the correct base I/O port
address), Disabled, 3F8h/COM1, 2F8h/COM2, 3E8h/COM3, or 2E8h/COM4.
The Optimal and Fail-Safe default settings are Auto.
Serial PortB Mode This option specifies the operating mode for serial port 2.This option appears
only if the Onboard Serial PortB option is not set to Auto or Disabled. The
settings are IrDA, ASK IR, or Normal. The Optimal and Fail-Safe default
settings are Normal.
IR Duplex Mode This option specifies the infrared transmission method. This option appears
only if the Onboard Serial PortB option is not set to Auto or Disabled. The
settings are Full or Half. There are no default settings.
Cont'd
Chapter 2 AMIBIOS Setup 63