John Lewis JLBIDW 1201 Instruction Manual page 22

Malfunction
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
The start of the washing
programme does not occur.
Once the checks have been carried out,
switch on the appliance. The programme
continues from the point at which it was
interrupted.
The washing and drying results are not satisfactory
The dishes are not clean.
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose
is blocked.
The connection of the water
inlet hose is not correct.
The water inlet hose is
damaged.
There is a blockage in the sink
spigot.
The connection of the water
drain hose is not correct.
The water drain hose is
damaged.
The appliance door is open.
The mains plug is not
connected in the mains socket.
The fuse in the fuse box is
damaged.
If the malfunction occurs again or the display
shows an alarm code that is not listed in the
table, please contact our extended warranty
administrators. Refer to 'Repairs - after sales
service'.
The washing programme was
not applicable for the type of
load and soil.
22
Possible solution
Clean the water tap.
Contact your local Water
Authority.
Open the water tap.
Clean the filter.
Make sure that the connection
is correct.
Make sure that the water inlet
hose has no damages.
Clean the sink spigot.
Make sure that the connection
is correct.
Make sure that the water drain
hose has no damages.
Close the water tap and
contact our extended warranty
administrators. Refer to
'Repairs - after sales service'.
Close the appliance door.
Connect the mains plug.
Replace the fuse.
Make sure that the washing
programme is applicable for the
type of load and soil.