Toshiba GA-1200 Scanning Manual page 139

Error code
9B In the offramp gateway function, the for-
warding of the InternetFax or Email was
stopped by the offramp security setting and
forwarded to a designated address as an
error because the Fax number of the desti-
nation was not registered in the address
book.
9C In the offramp gateway function, the for-
warding of the InternetFax or Email was
stopped and forwarded to a designated
address as an error because the Fax num-
ber of the destination includes an invalid
letter or 41 or more destinations are speci-
fied.
9D In the offramp gateway function, the for-
warding of the InternetFax or Email was
stopped because the Fax number the desti-
nation includes an invalid letter or 41 or
more destinations are specified.
9E The divided InternetFax/Email could not be
received properly for any of the following
reasons:
The reception was not completed within
the waiting period specified for receiv-
ing divided data.
A setting for receiving divided data
turned disabled during the reception.
The divided data were sent in a format
which this equipment does not support.
9F Connection to a POP3 server failed.
Cause Countermeasure
Check the Fax number in the RECEPTION
JOURNAL or on the forwarded data, and
then notify the sender that the forwarding
was stopped.
If necessary, refer to the Setup Guide for
Scanning Functions or the Operator's
Manual for Facsimile Function and regis-
ter the Fax number into the address book.
Check the Fax number in the RECEPTION
JOURNAL or on the forwarded data, and
then correct it (if 41 or more destinations are
specified, set them within 40). Then ask the
sender to retry the transmission.
Check the Fax number in the RECEPTION
JOURNAL, and then correct it (if 41 or more
destinations are specified, set them within
40).
Refer to the Setup Guide for Scanning
Functions and set "Enable Partial Email"
correctly. Then ask the sender to retry the
transmission. If the divided data were sent
in a format which this equipment does not
support, contact your system administrator.
Check if the network cable is connected cor-
rectly and also the POP3 server is running
correctly. Or refer to the Setup Guide for
Scanning Functions and set the POP3
correctly.
Error code table 137