Clean Operating Screen And Housing; What To Do If - John Lewis JLTDC11 Instruction Manual

Clean operating screen
and housing
Caution! Do not use furniture
cleaners or aggressive cleaning agents
to clean the machine.
Use a damp cloth to wipe down the
operating screen and housing.

What to do if ...

1)
Problem
Dryer not connected to mains supply.
Dryer does
not work. Loading door opened.
The Start/Pause button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactor
y drying
Max. loading exceeded.
results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
does not Filters not locked in place.
close
Err ( Error ) Attempt to change parameters after start
on the LCD. of the programme.
Programme selector in Off position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
on LCD
Programme
Full water reservoir.
inactive
Possible cause
Plug in at mains socket. Check fuse in fuse
box (domestic installation).
Close loading door
Press the Start/Pause button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
Empty water reservoir
Pause button.
20
Remedy
2)
3)
3)
4)
.
3)
, press Start/