Adjusting The Level Of Conductivity - John Lewis U30401 JLTDC 07 Instruction Manual

Adjusting the level of conductivity

Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly
influence the residual humidity of the laundry at the end
of the cycle.
Your dryer allows you to regulate the sensitivity of the
drying sensor based on conductivity values of the water
by using the following procedure
To establish the hardness of your water to correspond
with the table opposite please contact your local water
authority.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons
Quick and Start/Pause until «C0» appears on the digits.
Adjusting the level of conductivity:
Press the button Start /Pause sequentially: the level of
conductivity is indicated by the lighting of the horizontal
.
hyphens
Memorising the new setting:
.
Display
C C 0 0
C C 0 0
C C 0 0
Simultaneously press down the buttons Quick and
Start/Pause until the previous drying cycle time appears
again on the display and the buzzer sound
19
Conductivity Approximative
degree value (µS/cm)
Low < 300
Medium 300 - 600
High > 600
s.