What To Do If; Washing Machine; Troubleshooting - BALAY Washing Machine Instructions For Use Manual

What to do if...

Water is leaking out – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply. – (Start/Reload) not selected?
Detergent not dispensed. – Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
The appliance door will not – Safety function active. Programme stopped?
open. – (without final spin) selected?
– Can be opened by emergency release only?
– Door locked after the washing machine is switched off: Switch on the washing
machine and wait for 5 seconds.
The selected programme does – (Start/Reload) or
not start. – Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is not – (without final spin) selected?
drained. – Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
No water can be seen in the – Not a fault. Water remains inside below the visible area.
drum.
Spin result not satisfactory. – Not a fault. Spin control system has stopped the spin cycle. Uneven distribution of
Laundry wet/too damp. laundry.
Distribute large and small items of laundry evenly in the drum.
– menos
– Selected speed too low?
Programme duration changes – Not a fault. The program time can vary according to the distribution of laundry, with
suddenly during operation. it therefore being possible for the display panel to show adjustments in the
duration.
Spin cycle performed several – Not a fault. The balance control system has detected an imbalance and is
times. attempting to redress this by repeating the spin.
Residual water in the – Not a fault: the action of the care product is not affected.
compartment for care products. – Clean the compartment if necessary
Odour formation in the washing – Run programme algod. (Cottons) 90 °C without laundry. Use standard detergent.
machine.
Status display flashing. – Too much detergent used?
Appliance has detected a If foam is escaping from the detergent drawer: mix 1 tablespoon of fabric softener
detergent overload. with ½ litre of water and pour into compartment II (not with outdoor or down
fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation, – Are the appliance feet fixed?
vibrations and "wandering" Secure the appliance feet
during the spin cycle. – Transportation safety devices removed?
Remove transportation safety devices
Display panel/indicator lamps – Energy-saving mode
remain turned off while the – Power cut?
machine is working. – Fuses triggered? Reset/change the fuse.
– If the fault occurs repeatedly, call customer services.
Programme sequence longer – Not a fault. Unbalanced load detection system adjusts imbalance by repeatedly
than usual. distributing the laundry.
– Not a fault: foam detection system active; adds an additional rinse cycle.
Detergent residues on the – Occasionally, phosphate-free detergents contain water-insoluble residues.
laundry. – Select
If you cannot correct a fault yourself or if a repair is necessary:
o
– Turn the programme selector to (stop) and remove the mains plug from the socket.
– Turn off the water supply and call customer services
page 10.
page 4.
page 3, 4.
page 9.
(h) (Ready in) time selected?
page 5.
page 3, 4.
page 10.
(Reduced Ironing) selected? page 5.
page 5.
page 9.
Installation instructions.
Installation instructions.
page 5.
(Rinse)/ (Spin) or brush out the laundry after washing.
Installation instructions.
Read these instructions and the separate
installation instructions before operating
the washing machine.
Instructions for use
Observe the safety instructions on
page 8!
11
Washing
Machine
en