Kenwood TK-361SA Service Manual page 7

2. Mounting the chassis to the case assembly
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis q.
2. Attach the speaker to the speaker recess of the case as-
sembly w. Make sure the speaker is securely inserted.
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
3. Insert the upper part of the chassis into the case assem-
bly e.
Caution: Take care that the speaker lead wire is not
caught by the microphone element.
4. Press the chassis r and the case assembly together to
attach them.
Caution: If the packing of the SP/MIC does not come
to the correct position after attaching the chassis to the
case assembly, reposition the packing with your fi ngers.
3. Attaching the antenna receptacle to the chassis
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle
comes to the center of the case hole.
Tighten this screw first.
Tighten this screw second.
DISASSEMBLY FOR REPAIR
4. The nuts of the volume knob and channel knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is stainless steel, and
the nut of channel knob is brass)
Use the following jig when removing the nuts of the vol-
ume knob and channel knob.
• Jig (Part No. : W05-1012-00)
Volume Knob
(Stainless steel)
5. Screw sequence for mounting the TX-RX unit to
the chassis
Attach the TX-RX unit to the chassis using the screws in
the order shown in the drawing below.
TX-RX UNIT
Component side view
6. Connecting the speaker wires to the TX-RX unit
Note: To connect the speaker wires, you must solder it
to the location of the TX-RX unit as illustrated below.
TK-361SA
Channel Knob
(Brass)
SP–
SP+
TX-RX UNIT
Component
side view
7