Kenwood TK-361SA Service Manual page 6

TK-361SA
■ Removing the battery release lever from the
case assembly
1. Press the upper part of the lever toward the inside of the
case assembly. One side of the shaft will be removed q.
2. Lift and remove the battery release lever from the case
assembly w.
■ Attaching the battery release lever to the case
assembly
1. Insert one side of the shaft into the hole at the lever fi t-
ting section on the case assembly q.
Caution: The thin spring (G01-4543-14) should be posi-
tioned above the two tabs of the lever.
2. Tilt the battery release lever slightly forward w, so that
the thick spring (G01-4542-04) is positioned below the
case surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly
by pressing the battery release lever e until it snaps into
place r.
Caution: Be careful not to tilt the battery release lever
too forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a
possibility of damaging the two tabs.
Two tabs
A thick spring
6
DISASSEMBLY FOR REPAIR
A thin spring
Shaft
■ Assembling the battery release lever
1. Place the lever w onto the stopper q.
2. Place the thick spring e onto the lever.
3. Hook the right and left ends of the thin spring r onto
the tabs of the stopper, then place the thin spring onto
the lever t.
4. Slide the shaft through the hole of the stopper and lever
y.
■ Cautions for assembly
1. Attaching the positive terminal to the chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX
unit onto the chassis.
1. Remove the holder assembly w from the packing q of
the positive terminal.
2. Mount the packing of the positive terminal into the chas-
sis hole e.
3. Mount the holder assembly into the packing of the posi-
tive terminal r.