Hitachi SJ100DN DeviceNet Series Instruction Manual page 74

Error Responses to Set_Attribute_Single – In certain conditions the inverter cannot
Set an attribute as the host has requested. For example, the host's data might be out-of-
range for the specified parameter. The inverter will return an error code, listed for the
specific condition in the table below.
Error Condition
The inverter is in Run Mode
A trip, undervoltage, or trip-retry exists
Software lock mode enabled
Executing auto-tuning
Value less than start frequency setting
Value less than lower frequency limit setting
Value more than upper frequency limit setting
Value more than maximum frequency setting
Out-of-range condition not listed above
NOTE: The Message Router Object (Class ID = 2 hex) is supported, but has no setting.
Category
Class Revision
Instance 1 MAC ID
Baud rate
BOI
Bus OFF counter
Allocation information choice
byte
Master's MAC ID
Service Name
Get_Attribute_Single
Set_Attribute_Single
Allocate_M/S_Connection_Set
Release_M/S_Connection_Set
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Device state conflict
Invalid parameter
(check F_01, A_03,
A203, A_20–A_35,
A220, A_38, A_52,
A_61, A_62)
Invalid parameter
DeviceNet Object (Class ID = 3 hex)
Attribute ID
1
1
2
3
4
5
—
Supported Services, DeviceNet Object
Code
0Eh
10h
4Bh
4Ch
SJ100DN Inverter
Type
Type
code
10h
20h
Access
Data Type Initialization
Rule
Get UINT 2
Get/Set USINT 63
Get/Set USINT 125k bits/sec.
Get BOOL 0
Get/Set USINT 0
Get BYTE
— USINT
Description
73
Specific
error code
00
01
02
04
00
01
02
03
04
—
—