1848Gv And 1848Hv Only - Assemble And Install Mower Deck; Install Rear Gage Wheels; Install Mower Deck - Sabre 1842GV Operator's Manual

1848GV and 1848HV Only - Assemble and

Install Mower Deck

Install Rear Gage Wheels

1. Install rear gage wheels, one on each side, using bolt
(A), bushing (B), washer (C), and tighten with nut (D).
2. Adjust gage wheels after mower deck is installed.
(See Adjust Mower Gage Wheels in Operating the
Mower section.)
Install Mower Deck
CAUTION: Avoid injury, before installing
mower on machine: STOP engine. Remove
key. Wait for all moving parts to STOP.
Avoid injury from loaded spring: LOCK lift
lever before installing mower.
Avoid injury from spring loaded rod: Make
sure you have a tight grip on drive belt
tension rod when installing.
1. STOP engine, LOCK park brake, push PTO switch
down to DISENGAGE, turn key to the OFF position, and
remove key.
2. Raise mower lift lever to TRANSPORT (upper)
position.
3. Slide mower under the tractor.
4. Put wood blocks under each side of mower.
5. Put mower lift lever in the MOWING (lower) position.
6. Install rear draft arms, one on each side of tractor, to
mower lift brackets with spring loaded J-pins (A).
7. Put front lift rod assembly (B) in slotted brackets (C)
on mower deck and install the front lift rod assembly to
the front of the tractor frame.
8. Push up on lever (D) and lock into tractor frame.
ASSEMBLY
Assembly - Page 5
D
C
B
C
B
A
M88571
A
M88577
D
M88578