Service Interval Chart; Servicing Your Machine - Sabre 1842GV Operator's Manual

Servicing Your Machine

Please use the following timetables to perform routine maintenance on your machine. Service
procedures included in this manual but not on this chart are to be performed on an as needed basis.
IMPORTANT: If you operate mower in extreme heat, dust or other severe conditions, service
more often than shown below.
After the first 5 hours of operation (break-in period):
• Check/tighten all hardware
• Check wheel bolt torque (also check again at 50 hours for break-in, then every 200 hours)
• Change engine oil (also change oil again at 50 hours for break-in, then every 50 hours)
• Lubricate front steering spindles, wheel bearings and axle pivot
Service to be Performed
Test safety systems
Check fuel level
Check engine oil level
In severe conditions lubricate all mower spindles
In severe conditions check and clean
engine air cleaner
Check tire pressure
Check cutting height
Check/tighten hardware
Change engine oil
Change engine oil filter
Change/clean engine air cleaner pre-cleaner
Change/clean engine air cleaner cartridge
Replace fuel filter
Lubricate mower spindles
Clean battery
Lubricate front steering spindles, wheel bearings
and axle pivot
Check automatic transmission oil level
Replace spark plugs
Clean cooling shrouds and cooling areas

SERVICE INTERVAL CHART

Service Interval Chart - Page 41
Intervals in Hours
Every Every
Before
25 50
Each Use
X
X
X
X
X
X
X
X
X
X
X
X
Every Every
100 200
X
X
X
X
X
Yearly
X
X