Using Lift Lever To Raise And Lower Mower; Adjusting Cutting Height - Sabre 1842GV Operator's Manual

Using Lift Lever to Raise and Lower Mower

Check out the two different lift lever positions before
operation:
• TRANSPORT (UPPER) POSITION: Raises mower
for transport.
• MOWING (LOWER) POSITION: Maintains cutting
height set by mower height control yet allows deck to
float over uneven terrain.
To put mower in MOWING (lower) position:
• Pull lift lever (A) back slightly.
• Push in button (B).
• Push lever forward until it latches down.
To put mower in TRANSPORT (upper) position:
• Push down on lift lever (A) slightly.
• Push in button (B).
• Pull lever back towards you until it latches.

Adjusting Cutting Height

IMPORTANT: Lift lever must be in TRANSPORT
(upper) position before turning cutting height
knob.
NOTE: Adjust cutting height after you change
cutting height. (See Adjusting Mower Gage Wheels
in this section.)
Cutting height can be adjusted from approximately
25–100 mm (1–4 in).
When lift lever is in TRANSPORT (upper) position (lift
lever all the way back), cutting height is approximately
100 mm (4 in).
Knob (A) has cutting height identification numbers
embossed in it. To change or attain cutting height
desired:
• Pull lift lever all the way back to TRANSPORT (upper)
position.
• Turn cutting height knob (A) to desired cutting height
position. Mower will be at this cutting height each time
you lower it.
OPERATING MOWER
Operating Mower - Page 31
B
A
A
M88553
M88564