Conversion Kit# 731-969 From Ng To Lp - FPI E33-NG1 Owners & Installation Manual

CONVERSION KIT# 731-969 FROM NG TO LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LPG Conversion
Kit and one DC Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part # Description
1 904-529 5/32" Allen Key
1 904-641 Burner Orifi ce #50
1 918-590 Label "Converted to
LPG"
1 908-528 Red LPG Label
1 910-037 LPG Injector
(Pilot Orifi ce)
1 918-485 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External
Star
1 904-330 Nut 8-32 Hex
2 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4
Pan Head
2 904-553 Screw #8 x 1/2
Type "B", Black Oxide
1 910-073 Spark Generator
Battery Holder
1 910-074 Spark Generator
Switch C/W Wire
1 910-078 Battery Size AA
Energizer En91
1 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power
Cord, Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
Installation of LPG
Conversion Kit:
1) Shut off the gas supply.
2) Remove the louvers and glass door.
3) Remove the logs and grate (refer Log
Installation section in E33 Manual).
Ensure you slide the bottom log 03-17 off
to the right-hand side to avoid chipping.
E33 FPI Direct Vent Gas Insert
for E33-1 using SIT 820 NOVA Gas Valve
IF IN DOUBT DO NOT DO THIS CONVERSION !!
4) Remove front base brick.
5) Remove burner by unscrewing the 2
screws.
6) Pull off the pilot cap to expose the pilot
orifi ce.
7) Unscrew the pilot orifi ce with the 5/32"
allen key and replace with the LPG pilot
orifi ce provided in the kit, then replace
pilot cap.
8) Remove burner orifi ce with a 1/2" wrench,
while using a 9/16" wrench to hold onto
the elbow behind the orifi ce and discard
orifi ce.
Burner Orifi ce Removal
9) Reinstall new burner orifi ce LPG stamped
#50 and tighten.
INSTALLATION
10) Turn control knob to the "OFF" position.
11) Remove the black protection cap by hand
from the hi/low knob (Fig.1).
Fig. 1
12) Insert a 5/32" or 4mm Allen wrench into
the hexagonal key-way of the screw
(Fig. 2), rotate it counter-clockwise until it
is free and extract it.
Fig.2
13) Check that the screw is clean and if
necessary remove dirt.
14) Flip the screw (Fig. 3).
Fig.3
15