Tri-Watch - Simrad RS86 Manual

Note
Note

2.7 Tri-Watch

Note
Press & hold
Note
Note
E04819 Issue 1.0
If the radio detects a signal on the watch channel, it will lock
onto this and the large digits will change to show the watch
channel.
All other stations will also show the Dual Watch display.
Normal VHF functions will not be available when in Dual Watch
mode. To exit Dual Watch, press 16 or O
fistmike from the cradle.
Tri-Watch allows the radio to scan between the selected work-
ing channel, the User channel, and the watch channel.
Tri-Watch cannot be selected if the User channel is set to Ch16.
To enter Tri-Watch, select the required working channel, press
S , and then press and hold 3 (DW) for 2 seconds.
HIFT
If Tri-Watch is selected while the handset/fistmike is off the cra-
dle, the display will show "PLACE BACK ON CRADLE". If
the handset/fistmike is replaced within 10 seconds of selecting
Tri-Watch, it will automatically initiate Tri-Watch.
The display will show "T/W" – the large digits on the display
indicate the working channel, with the User channel and watch
channel shown below in small digits (Fig 2.6).
INT
If the radio detects a signal on the User or watch channel, it
will lock onto this and the large digits will change to show the
relevant channel.
All other stations will also show the Tri-Watch display.
Normal VHF functions will not be available when in Tri-Watch
mode. To exit Tri-Watch, press 16 or O
fistmike from the cradle.
10
T/WAAAAA
USERBBBBB6
Fig 2.6 - Tri-Watch mode
N
Instruction Manual
/C, or lift the handset/
N
16
/C, or lift the handset/
17