Stiga Primo 2008 Workshop Manual page 24

Edition Manual
2008-03-18 Workshop Manual, Stiga Primo
3.1.3 Assembly
1. Hook on the wire to the rear steering lever.
2. Mount the 2 pulleys (E) with the wire at the
right side of the machine.
Note!
Locate the wire as observed during the
dismantling.
Check that the wire not interface with
frame parts, rods, levers etc.
Lubricate the pulleys and mount them
according to the figure.
See "3.1.4 Steering pulleys".
3. Turn the steering wheel until the wire rivet
hole in the steering roller is facing forwards.
4. Wind up the wire on the steering roller.
Keep the right part of the wire stretched by
blocking or holding the rear wheels.
Start winding at position (A), wind 1,25 turns
and push in the rivet (B) into the hole in the
steering roller.
5. Continue to wind up the wire another 1,25
turns.
Chapter
3 Steering
E
A B
Page
3
E