Stiga Primo 2008 Workshop Manual page 23

Edition Manual
2008-03-18 Workshop Manual, Stiga Primo
3.1 Steering wire
3.1.1 Description
The steering power from the steering wheel is
transmitted to the rear wheels by a wire as
follows:
• The roller (A) is turned by the steering wheel
and mowes the wire (B).
• The wire is pulling the lever (C), which affects
the wheels by the rods (D)
3.1.2 Dismantling
Note!
Observe how the wire is located above/
under rods, arms etc. This observation is
helpful at the installation of the new wire.
1. Remove the four steering pulleys (E). Use a
15 mm and a 17 mm wrench.
2. Remove the nut (F), holding the wire end.
Use a 13 mm wrench and a pliers to hold the
wire end.
3. Remove the spring
4. Unwind the wire from the steering roller and
unhook it from the rear attachment.
5. Remove the wire from the machine.
Chapter
3 Steering
D
C
E
Page
2
A
B
E
E
E
F