Procedure 2.3 - Accessing The User Parameter Program - Precor 9.31 Service Manual

Procedure 2.3 - Accessing the User Parameter Program

This procedure allows you to change the following settings:
• Set Measurement Units
• Enable/Disable Password
• Set User Name
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
Press keys RESET,5,6,7,1 sequentially.
2.
3. If you are testing a 9.33 or 9.35 treadmill continue with step 4. If you are testing a 9.31
treadmill skip to step 17.
The display will momentarily read, DIAGS - SET USER PARAMETERS.
4.
The display will momentarily read SELECT UNITS
5.
6. The currently selected measurement unit will then be displayed.
7. Use the , keys to scroll through the available measurement units.
Press the ENTER key to select the currently displayed measurement unit.
8.
The display will momentarily read, PASSWORD
9.
keys to select either PASSWORD ENABLED or PASSWORD DISABLED.
10. Use the ,
11. Press the ENTER key to exit diagnostics (9.33 only) or to continue to set user name (9.35
only).
12. The display will momentarily read, USER NAME.
13. Up to four user names may be entered. If user names have not been previously entered the
default user names will be USER1, USER2, USER3 and USER4.
14. The USER1 name will be displayed first. The ENTER key will select USER2, then USER3,
then USER4.
15. With the user name to be edited displayed, use the INCLINE
character position to be edited. Use the SPEED
placed in the selected character position. The user name can be a maximum of five
characters.
9.31, 9.33, 9.35 Treadmill
, INCLINE
, SPEED
keys to select the letter to be
, to select the
Page 11