Use And Care - Char-Broil Commercial Series Assembly, Use And Care Manual

Use and Care

Connecting Your Grill to the
Natural Gas Source
IMPORTANT: IMPORTANT:
IMPORTANT: Regulator supplied with grill MUST be IMPORTANT: IMPORTANT:
utilized for natural gas connection.
1. Coat pipe nipple with gas resistant dope. Screw socket onto gas
manifold at gas source (A).
2. Connect unattached end of natural gas hose to socket. Push sleeve
back on socket (B) and insert plug until sleeve snaps forward, locking
plug into socket.
When socket and plug are connected, valve in socket opens automati-
cally to permit full gas flow. When coupling is disconnected, valve in
socket instantly and positively shuts off flow of gas. Because valve in
socket positively shuts off flow of gas, grill can be disconnected from gas
source by disconnecting hose from socket. Socket can be left on
manifold of gas source if so desired.
WARNING WARNING WARNING
WARNING WARNING
• Connection to gas source must be done by a
certified plumber.
A A A A A
Pipe Nipple
Gas
Flow
Gas Manifold
10 • 463231603
Sleeve
Socket
Insert cover in socket
when hose is removed
Push sleeve back to attach
B B B B B
Socket
With proper assembly, plug cannot be removed without
pushing sleeve back. To disconnect, push sleeve back and pull plug
out of sleeve (this automatically shuts off gas).
Please Note: Hose and assembly are A.G.A. certified and C.G.A.
listed for natural gas, manufactured gas, mixed gas and for
liquefied petroleum and for LP Gas-Air mixtures on basis of 0.64
specific gravity for 1000 BTU's per cubic foot of gas at 0.3 in.
water column pressure drop. Only ANSI Z21.54 approved hoses
should be used with this grill.
The appliance and its individual shut off valve must be discon-
nected from the gas supply piping system during any pressure
testing of that system at test pressures in excess of
1/2 psig (3.5kPa).
The appliance must be isolated from the gas supply piping
system by closing its individual manual shutoff valve during
any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa).
WARNING WARNING
WARNING WARNING WARNING
• Do not use hard metal piping of any kind to
connect this type of grill to natural gas source. Use
ONLY hose specified by Char-Broil. Using hard
metal piping or convoluted metal tubing is an
unsafe practice. Movement of the grill can cause
breakage of metal pipe.
Hose
Plug
Hose
Plug