Sony DVP-NC600 Service Manual page 6

6) Mount the lock lever (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
Spring
Lock lever
(lock lever)
Gear
(main)
8) Rotate the gear (main) in the direction of arrow A by 90°
turn. (Gear (U/D) is up position.) (See Fig. 6.)
9) Mount the Gear (rev). (See Fig. 6.)
10) Fix three stopper washers on the groove of shafts.
(See Fig. 6.)
Groove
*
* *
Shaft
Two stopper
washers
Gear (main)
Spring
(lock lever)
Lock lever
Fig. 5
Stopper washer
Gear (rev)
Gear (U/D)
A
Fig. 6
5. HOW TO SERVICE MB-98 BOARD
• Jig (J-6090-107-A) Extension cable
• Jig (J-6090-108-A) Extension cable
Stand
(with CK-106 Board)
CK-105 board
Eight flexible flat cables
FFC 5P (EXCEPT DVP-NC600), FFC 9P,
FFC 15P, FFC26 P,
FFC 9P (DVP-NS500P/NS700P),
FFC 15P (DVP-NS400D),
FFC 25P
(EXCEPT DVP-NS300 J model/NC600),
FFC 29P (DVP-NS300 J model)
Two flexible flat cables
FFC 11P, FFC 25P
1) Remove the upper case and reinforcement (C) from the set.
(Refer to 2-1)
2) Remove the rear panel. (Refer to 2-1)
3) Remove the MB-98 board. (Refer to 2-1)
4) Set the stand (with CK-106 board) as shown in Fig. 7.
4 Two screws (B3)
3 Connector (CN101)
– 6 –
1 MB-98 board
2 Stand
(with CK-106 board)
Fig. 7