Note: Follow the disassembly procedure in the numerical order given.
2-1. UPPER CASE, REINFORCEMENT (C)
REMOVAL
4 Upper case
1 Two tapping
screws
5 Two screws
(B3)
6 Reinforcement (C)
2-2. FRONT PANEL SECTION REMOVAL
2 Two screws (B3)
6 Front panel section
5 Claw
4 Two claws
SECTION 2
DISASSEMBLY
3 Three tapping
screws
2 Two tapping
screws
1 Two connectors
(CN401, 404)
3 Claw
2-3. REAR PANEL REMOVAL
5 Claw
2 Harness
1 Connector
(CN101)
2-4. MB-98 BOARD REMOVAL
3 Flexible flat cable
(FMD-025: CN202)
3 Flexible flat cable
(FCM-014: CN402)
2 Pull the tray in the
direction of arrow B.
B
A
1 Insert a flat-blade screwdriver into a hole at the bottom,
and rotate the cam gear in the direction of arrow A.
2-1
DVP-NC600
8 Rear panel
3 Screw (B3)
7 Three connectors
(CN202, 203, 204)
6 Flexible flat cable
(FAM-008: CN201)
3 Flexible flat cable
(FMM-036: CN201)
5 Four screws
(B3) (ring)
6 MB-98 board
4 Connector
(CN101)
4 Claw