Floppy Disk - TEC B-450 SERIES Maintenance Manual

7. PROGRAM DOWN LOAD FOR PRINTER
7. PROGRAM DOWN LOAD FOR PRINTER
The program for the printer has been written onto the flash ROM. If the program is updated, due to the
additional/change of the specification, download the program from the PC to the printer with download
floppy disk and RS-232C interface or Centronics interface.

7.1 FLOPPY DISK

1) Media: 3.5 inch (2HD, 1.44 MB)
2) Program Disk: 1 disk (this floppy disk contains the main program to be written onto the printer and the
tool program for download.) The system disk is provided for the printer.
7.2 SETUP
The transmission control code must be set to either automatic selection or manual selection ({,I,}).
You cannot perform a down load with any other control codes.
Refer to Section 6.3.10 Control Code Selection.
7.2.1 Connecting the Printer to the PC
7.2.2 Program Download FDK (3.5", 2 HD, 1.44 MB)
RS-232C Cable or
Centronics Cable
•Windows 95 or later version
•Set the communication parameters as follows:
Baud rate: 9600 BPS
Parity: EVEN
B-452-QQ/QP
INSTALL KIT V1.0A
15th November 1996
FMRM00XXXXX: 1200
3400
V001. 002
Copyright 1998
TEC CORPORATION
All Rights Reserved
7-1
EO18-33003A
7.1 FLOPPY DISK
Fig. 7-1
Model Name
Revision
Version
Master FDK creation date
Check sum (main)
Check sum (Boot)
Software No.
FDK Version
Fig. 7-2