Table of Contents
Advertisement
Your belt/disc sander has been shipped completely
assembled except for the sanding disc, disc guard, miter
gauge, work support, and worktable.
I Carefully remove all parts from the shipping carton.
I Do not discard the packing material until you have carefully
inspected the belt/disc sander, identified all parts, and
satisfactorily operated your new tool.
I If all parts have been included, proceed to assembly.
I If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.
I Examine all parts to make sure no breakage has occurred
during shipping. Any damaged or missing part should be
replaced before attempting to use the tool.
Note: If any parts are damaged or missing, do not attempt
to plug in the power cord and turn the switch on until the
damaged or missing parts are obtained and are installed
correctly.
Check all loose parts with the list below. Assemble according to the instructions on the following pages.
I Sanding Disc
I Disc Guard
I Phillips Screws (2)
I Socket Head Screws, M8 x 12 (2)
I Washers (2)
MITER GAUGE
WORK
SUPPORT
UNPACKING
LOOSE PARTS
SANDING DISC
SOCKET HEAD
SCREWS
WARNING:
Do not allow familiarity with your belt/disc sander to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Do not attempt to assemble the belt/disc sander, plug in
the power cord, or turn on switch if any parts are damaged
or missing. Failure to heed this warning could result in
serious personal injury.
I Miter Gauge
I Hex Key
I Worktable
I Work Support
I Operator's Manual (not shown)
DISC GUARD
WASHERS
7
PHILLIPS
SCREWS
WORKTABLE
HEX KEY
Fig. 2
Hide quick links:
Advertisement
Table of Contents
