Table of Contents
Advertisement
The green PWR and RUN LEDs illuminate. The green link LED on the ESC RJ-45 cable
illuminates (see
Figure
on the ESC RJ-45 connector flickers, indicating network activity.
DBG Connector
PWR LED
Figure 1.
3. Start ZDS II.
4. Open one of the projects listed in the samples directory of your ZDS II installation.
5. Select Project
→
6. Select the Debugger tab.
7. In the Debug Tool drop-down menu, select EthernetSmartCable.
8. Click the Setup button. Your ESC will be listed in the Smart Cables Available list.
Check the box for your ESC, then click the OK button.
If you have more than one ESC, you can uniquely identify them by comparing
Note:
the MAC address listed in the Smart Cables Available list with the label on
the bottom of the ESC.
UM020702-0107
1), indicating a live Ethernet connection. The green activity LED
RUN LED
Ethernet Smart Cable, Front View and Rear View
Settings. The Project Settings window appears.
5 VDC Power In
Activity LED
Installing the Ethernet Smart Cable
Ethernet Smart Cable
User Manual
Page 3
Ethernet Connector
Link LED
Advertisement
Table of Contents
