Positioning Belt - Pride Euro Seat 2 Basic Operation Instructions

20

POSITIONING BELT

Your Euro Seat 2 may be equipped with a positioning belt that can be
adjusted for operator comfort. See figure 16. The positioning belt is
designed to support the operator so that he/she does not slide down or
forward in the seat. The positioning belt is not designed for use as a
restraining device in a motor vehicle.
WARNING! The positioning belt is not designed for use as a
seat belt in a motor vehicle. Nor is your power chair
suitable for use as a seat in any vehicle. Anyone traveling
in a vehicle should be properly belted into seats approved
by the vehicle manufacturer.
To install the positioning belt:
1. Insert the screw through the washer and the mounting tab at the end of
the positioning belt. See figure 16.
2. Install the screw through the steel spacer, washer, and then the seatback
including the large zinc spacer.
3. Install the washer and nut to the assembly and then tighten the nut using
two adjustable wrenches.
4. Repeat steps 1-3 for the other side.
To adjust the positioning belt:
1. Once seated, insert the metal tab on one side of the belt into the plastic
housing on the opposite side until you hear a click.
2. Pull the excess strap attached to the metal tab until it is secure, but not
so tight as to cause discomfort.
Euro Seat 2 www.pridemobility.com
Basic Operation Instructions