Makita BLS712SF Instruction Manual page 27

Lower the handle fully and lock it in the
lowered position by pushing in the lock
pin. Square the side of the blade with
the face of the guide fence using a
triangular rule, try square, etc. Then
securely tighten the hex bolts on the
guide fence in the order from right side.
Make sure that the pointer points to
0" on the miter scale. If the pointer
does not point to
O",
loosen the screw
which secures the pointer and adjust the
pointer
so
that it will point to
0".
2) Bevel angle
i) 0" bevel angle
Push the carriage toward the guide
fence and tighten the clamp screw to
secure the carriage. Lower the handle
fully and lock it in the lowered position
by
pushing in the
lock
pin. Loosen the
lever at the rear of the tool. Turn the
0"
bevel angle adjusting bolt (lower
bolt) on the right side of the arm two
or three revolutions counterclockwise
to tilt the blade to the right.
Triang ar rule
A / -
- / /
Miter 'scale Pointer
0" bevel angle
I
adlusting bolt
Arm holder
27