Advertisement
This tool should be bolted with two bolts to
a
level and stable surface using the bolt
holes provided in the tool's base. This will
help prevent tipping and possible injury.
Installing
or
removing saw blade
CAUTION:
*Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the blade.
Use only the Makita socket wrench provided
to
install
or
remove the blade. Failure to do
so
may
result in overtightening
or
insufficient tightening of the hex bolt. This could cause
serious injury to operator or others in the general vicinity of the tool.
Lock the handle in the raised position by
pushing in the stopper pin.
Stopper pin
To remove the blade, use the socket
wrench to loosen the hex bolt holding the
center cover by turning it counterclockwise.
Raise the safety
cover and center cover.
11
Advertisement
