Advertisement
Maintaining maximum cutting capacity
This tool is factory adjusted to provide the max. cutting capacity for a 190 mm (7-1/2")
saw blade. When using a saw blade other than 190 m m (7-1/2") saw blade, adjust the
lower limit position of the blade as follows:
First, remove the battery cartridge. Push the carriage toward the guide fence fully and
lower the handle completely. Use the socket wrench to turn the adjusting bolt until the
periphery of the blade extends slightly below the top surface of the turn base at the point
where the front face of the guide fence meets the top surface of the turn base. With the
battery cartridge removed, rotate the blade by hand while holding the handle
all
the way
down to be sure that the blade does not contact any part of the lower base. Re-adjust
slightly, if necessary.
7
Adjusting bolt
Guide' fence
Guide fence
Periphery
of blade
Top surface
of turn base
-_____----
'.
CAUTION:
After installing a new blade, always be sure that the blade does not contact any part of
the lower base when the handle is lowered completely. Always do this with the battery
cartridge removed.
Stopper arm
The lower limit position of the blade can be
easily adjusted with the stopper arm. To
adjust it, move the stopper arm in the
direction of the arrow as shown in the
figure. Adjust the adjusting screw so that
the blade stops at the desired p.osition
when lowering the handle fully.
15
Advertisement
