3. Holders and holder assembly (optional accessories)
The holders and the holder assembly can be installed on either side as a convenient
means of supporting workpieces horizontally. Install them as shown in the figures
below. Then tighten the screws firmly to secure the holders and the holder assembly.
I I
Screws
Holder assembly
I
Holder
Holder assembly
When cutting long workpieces, use the holder-rod assembly (optional accessory). It
consists of two holder assemblies and two rods 12.
Holder assembly
//
CAUTl
ON
:
Always support long workpieces level with the top surface of the turn base for accurate
cuts and to prevent dangerous loss of control of the tool.
18