Connection With The Mains; Installation And Connection Of The Pci Sending Card - EuroLite LSD User Manual

6.3 Connection with the mains

Finally, connect each display panel to the mains (90 - 260 V AC, 50/60 Hz) via its power supply cable. The
occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Caution! Do not connect display panels to the mains while they are folded.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation. The device
must only be connected with an electric installation carried out in compliance with the IEC standards. The electric
installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of 30 mA.

6.4 Installation and connection of the PCI sending card

6-3 Installation of the sending card
International
L
N
46/62
1. Turn off the
disconnect the power plug and
remove the case. Take anti-static
precautions (e.g. touch a metal
object) to avoid damage to the
computer.
2. Insert the sending card into a
free PCI slot of the computer.
Replace the case.
3. Connect the DVI port of the
sending card to the DVI port of the
computer via the supplied DVI
cable.
4. Connect the RJ14 jack of the
sending card to the RS-232 port of
the computer via the
adapter cable.
5. Make sure all connections are
correctly connected. Apply power to
the computer and start it.
6. If the green status LED of the
sending card is flashing constantly
(about 30 times per second) power
supply and data transmission is
established.
Caution! When the computer starts
up and the monitor remains black
after connecting the sending card,
turn off the computer and disconnect
the DVI cable from the sending card.
Reboot your computer and when
Windows has loaded, reconnect the
DVI cable.
00049757.DOC, Version 1.0
computer,
supplied