Testing Your System - C&K systems LED Keypad User Manual

LOCAL SYSTEM TEST
This option allows on-site testing of each zone in your system.
To initiate the SYSTEM TEST:
Enter your PIN (if required),
PIN
REQUIRED
push the
the digit "0", then push the # key.
.
Once the keypad lights go out, the system will be
ready for testing. Walk through the areas protected
by motion sensors; open and close protected doors and windows. Each time a zone is
faulted, its corresponding red ZONE light on the keypad will begin flashing, and the
keypad will chime.
.
To exit the system test, push any key.
WARNING: Your alarm system will not report alarms during the LOCAL SYSTEM TEST.
key, enter the digit "6",
6 0
25