Resetting Smoke Detectors - C&K systems LED Keypad User Manual

RESETTING SMOKE DETECTORS

OPTION
INSTALLED
When a smoke detector is triggered, the red ZONE light of the zone where it's
located will come on, and the bell/siren will sound.
Before you do anything else, evacuate the building. Don't go back
inside until your sure it's safe. When it's safe to do so, you can reset the
smoke detectors by doing the following:
Push the
the digit "2", and push the # key.
STANDBY BATTERY
OPTION
INSTALLED
Should there be a loss of AC power, the green POWER light on the keypad
will go out, and your alarm system will switch to its standby battery. If an AC
power failure lasts for more than 15 minutes, the system will send a signal to
the central station (if programmed to do so).
.
The standby battery should be replaced every three to five years with a recharge-
able 12 V 6.5 Ah sealed lead-acid battery (such as C&K Model 1265).
22
key, enter the digit "6",
6 2