Precor 9.17 Appendix page 34

7. Set the replacement lift motor in it's mounting position and secure it to the treadmill frame
with the clevis pin removed in step 6. Replace the hitch pin in the clevis pin.
8. Feed the lift motor cable to the lower PCA, and insert the lift motor connector into the lower
PCA. Replace the cable ties removed in step 4. Reconnect the lift motor ground wire.
9. Re-install the lower PCA shield. Reinstall the front lower cover.
10. If the treadmill is a 917, calibrate the lift and complete the installation per Procedure 4.1,
steps 3-8.
11. If the treadmill is a 917si, calibrate the lift and complete the installation per Procedure 4.2,
steps 3-7.
12. Set the treadmill in the upright position and test per Section 3.
917, 917si Treadmillr
Page 34