Condition For Programming Operations - TEC MA-1350-1 Series Programming Manual

Condition for Programming Operations:

At the top of each programming operation sequence in this chapter, "Condition" is attached. Unless
the register satisfies this condition, the programming operations will not be allowed.
When Condition "After ... Reset" is attached:
"After ... Reset" means that the designated reset report must be taken before entering the program-
ming (setting) operation. An error will result if the operation is attempted without taking the report.
However, it does not necessarily mean "immediately after ..." When the designated reset report has
already been taken and then some operations are performed in the "X", "Z", or "SET" mode, the
condition "After ... Reset" is still satisfied and the programming operation is stilled allowed. On the
contrary, when the designated reset report has been taken but then some sales data relating to
that report's output data are entered in the "REG", "MGR" or " - " mode, the programming opera-
tion will no longer be allowed and the same reset report must be taken again. Thus, the condition
"After ... Reset" indicates that all the sales data relating to the report data must be zero (except non-
resettable memory data). Because of this "Condition" requirement, the report data will be protected
from any inconsistencies of sales data entered in the period from a resetting of the report to another
resetting of the same report next time.
When Condition "Any time outside a sale" is attached:
It means that no condition is specified to a programming (setting) operation, and that the operation
is allowed any time outside a sale (but the cashier must be signed off if the Cashier Signing Method
option is selected).
- 18 -
EO3-11084
MA-1350-1 SERIES