TEC MA-1350-1 Series Programming Manual page 32

Address : 6
([CHECK TEND] Key Function)
Bit
No.
1 Total Function
2 Tender Function
3 Validation Print Contents on Over-tendering
4 Cashing with no purchase, using this key
5 Over-tendering (tendering an amount larger than the sale
total, resulting in calculation of change due)
6 In drawer Print on Reports
7 Finalization of R/A transaction
8 Validation Compulsory
Supplementary Description for Address 6:
Bit 1 & 2:
Bit 3: RESET status ............... Prints the sale total amount.
SET status .................... Prints the tendered amount.
In case of a short-tender, the tendered amount is always printed regardless of this bit status
selection.
Bit 4: RESET status ............... Customers' checks cannot be cashed outside a sale.
SET status .................... Customers' checks can be cashed with no purchase outside a sale.
Bit 5: This Bit status selection is effective only in tendering operation.
SET status .................... If this bit is SET and also Address 11 - Bit 1 is SET (for Short-tendering
Bit 8: SET status .................... When the [CHECK TEND] key is operated, the SLIP lamp will flicker
Initial SET Bit Nos.
Your Selection
Content
If both RESET or both SET, the [CHECK TEND] key functions as tender and total key.
Prohibited), an amount equal to the sale total is always required for
tendering.
to prohibit all the operations (including control lock position change
and cashier key change) other than the validation print. The status of
this bit is applicable in the REG or MGR position, and is not applicable
in the " - " position. When the [CHECK TEND] key is depressed, the
drawer will not open. It will open when the [VALIDATE] key is
depressed.
Follow Bit 2 status.
Follow Bit 1 status.
SALE TOTAL
PROHIBITED
ALLOWED
NOT COMPULSORY
- 30 -
MA-1350-1 SERIES
Selective Status
RESET
SET
TOTAL FUNC-
TION only
TENDER FUNC-
TION only
TENDERED AMOUNT
ALLOWED
ALLOWED
PROHIBITED
PRINT NON-PRINT
PROHIBITED
COMPULSORY
EO3-11084
2 3 4