Operating Instructions - Dennis Simplex 510 Instruction Manual

Before commencing ensure the turf is free from stones or other obstructions which may damage the cassette unit.
Set the height of cut to the required level (see page 10)
Check the engine.
Fill the fuel tank 3/4 full with unleaded petrol.
Always check the oil levels of the machine prior to commencing. Full details are given in the
accompanies this book. A daily check is recommended. (Recommended grade oil is SAE 10W-40).
Disengage the cylinder drive. (see next page)
Set the throttle control on the handle bars to the idle position.
Once the preparatory steps have been completed as outlined on page 7 the engine may be started. (See manufacturer
operating manual for full details).
1) Switch on the fuel tap.
2) Switch the handlebar cut off switch to ON, or depress deadmans handle (Item 1)
3) Set the throttle control to a half open position.
3) Shift the choke lever to the appropriate position. Honda engine set to the
if the engine is warm or the air temperature high.
4) Grasp the recoil start handle until resistance is felt, then pull it with force.
5) Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter.
6) Once the engine is started gradually 'open' the choke lever (move the lever towards the
position). Warm-up running of 3-5 minutes is recommended.
1) Set the throttle control to the
2) Switch the handlebar cut off to OFF or release deadmans handle.
3) Close the fuel tap.
Ensure the
Depress the
Pull the
Set the
Simplex
BEFORE YOU OPERATE THIS MACHINE YOU MUST READ AND STUDY THIS MANUAL.
IF YOU ARE IN ANY DOUBT PLEASE ASK YOUR EMPLOYER OR CONTACT US DIRECT.
IMPORTANT INFORMATION PLEASE READ ALL THE DETAILS IN THIS SECTION AND
FAMILIARIZE YOURSELF AND ALL MACHINE OPERATORS WITH THE CONTENTS.
position.
is disengaged.
(Item 15)
(Item 14) upwards.
to increase / reduce speed.
(Item 14) backwards.
position). The choke is not required
8
Manual, which
, or OPEN
SP20006_REV_0