Toshiba Satellite Pro T110DD Maintenance Manual page 202

Chapter 4 Replacement Procedures
Installing the LCD unit
The following describes the procedure for installing the LCD unit.
Install the LCD supports (LCD unit side) and hinge to the LCD and secure them with the
following screws.
 M22.5F FLAT BIND screw
1. Stand the LCD unit on the display cover and connect the LCD harness to the
connector on the back of LCD.
2. Stick the MYLAR tape on the connector of LCD harness.
3. Secure the LCD unit with the following screws, and connect LCD harness with CCD
FPC.
 M2.03.0F
4. Secure the display mask with following screws
 M2.04.0F
5. Cover screws with Screw MYLAR cover x4
NOTE: When installing the display mask, make sure there is no gap between the display
mask and the display cover.
Satellite T110D / Satellite Pro T110D / PORTEGE T110D Maintenance Manual (960-Q08)
FLAT BIND screw
FLAT BIND screw
x4
x4
x4
50