Chapter 4 Replacement Procedures
4.3
HDD
Removing a HDD-H9.5mm
The following describes the procedure for removing the HDD (See Figure 4-3-1 to 4-3-3).
CAUTION: Take care not to press on the top or bottom of a HDD. Pressure may cause
data loss or damage to the device.
1. Turn the computer upside down.
2. Remove the following screws with a T6-bit TORX securing HDD slot cover and
remove HDD slot cover.
M2.04.0U
3. Remove the following screws securing the HDD assembly.
M2.04.0F
4. Disconnect the HDD assembly from the connector on the HDD cable
Satellite T110D / Satellite Pro T110D / PORTEGE T110DMaintenance Manual (960-Q08)
FPH(T6) screw
FLAT BIND screw
MAIN HDD
Figure 4-3-1 Turn the computer upside down
x2
x4
11