Table of Contents
Advertisement
FCC Com p lian ce
State m e n t
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Radio and television interference
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with
the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
If necessary, consult a FlipStart-authorized service
provider or FlipStart. See the service and support
information that came with your FlipStart product. Or,
consult an experienced radio/television technician for
additional suggestions.
IMPORTANT: Any changes or modifications not
expressly approved by Vulcan Portals Inc. could void
the user's authority to operate the equipment.
This product was tested for EMC compliance under
conditions that included the use of FlipStart peripheral
devices. It is important that you use FlipStart periph-
eral devices to reduce the possibility of causing inter-
ference to radios, television sets, and other electronic
devices. You can obtain FlipStart peripheral devices
through a FlipStart-authorized dealer. For non-
FlipStart peripheral devices, contact the manufacturer
or dealer for assistance.
Responsible party (contact for FCC matters only):
Vulcan Portals Inc.
Product Compliance
505 5th Ave. S., Suite 900
Seattle, WA 98104
U.S.A.
Advertisement
Table of Contents
