Regulatory Information; Fcc Compliance Statement; Radio And Television Interference - FlipStart E-1001S User Manual

A
P P E N D I X

Regulatory information

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

Radio and Television Interference

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
If necessary, consult a FlipStart-authorized service provider or see the service and support
information that came with your FlipStart product. Or, consult an experienced radio/television
technician for additional suggestions.
Important: Any changes or modifications not expressly approved by Vulcan Portals Inc. could
void the user's authority to operate the equipment.
B
81